Important: 30mm Buttons Do Not Fit Original Panel Without Modification
Please note that the original metal panel was designed for buttons that are slightly smaller than typical 30mm buttons. We recommend purchasing a Blank Plexi Replacement Panel for Agetec HKT-7300 or Custom Etch Plexi Replacement Panel for Agetec HKT-7300 and Artwork Print and Cut for Agetec HKT-7300 Replacement Panel which has proper diameter for 30mm buttons. If you prefer to keep the metal panel, you must dremel the button holes to fit a 30mm button.
The .110" Button to Agetec HKT-7300 Harness Adapter allows you to attach a common Japanese button with .110" terminal to the 3 pin connector found on the arcade stick's pushbutton harness.
The classic Dreamcast arcade joystick - the Agetec HKT-7300 is affectionately known as the "green goblin" for its presentation of green buttons and balltop. Enthusiasts that still play iconic Dreamcast titles such as Capcom vs SNK 2, Street Fighter III: Third Strike, or Marvel vs Capcom 2 enjoy the 6-button configuration and overall feel. Modding the HKT-7300 is quite the challenge; the original buttons attach to a 3 pin connector found on the arcade stick's button harness. You can't otherwise install a Sanwa or Seimitsu pushbutton to the harness.
Each adapter harness uses .110" terminal female quick disconnects to attach to the .110" terminals of common Japanese arcade buttons. The other end sports a 3 pin male connector, which attaches to the female connector on the button harness. This simple approach creates a trouble-free installation of your favorite Japanese brand pushbutton into the Agetec fightstick.
Installation
These notes instruct you in replacing the entire panel. Please note that the original metal panel was not designed for 30mm buttons. We recommend purchasing a Blank Plexi Replacement Panel for Agetec HKT-7300 or Custom Etch Plexi Replacement Panel for Agetec HKT-7300 and Artwork Print and Cut for Agetec HKT-7300 Replacement Panel which has proper diameter for 30mm buttons. If you prefer to keep the metal panel, you must dremel the button holes to fit a 30mm button.
%%Panel._Plex_AGETEC_Notes%%
