Blank Plexi Replacement Panel for Agetec HKT-7300

%%Panel._Plex_Notice%%

%%Panel._Plex_PlexReplace%%

The art cover replacement top panel offers one of the best ways to customize your joystick.  The plexiglass sits atop specially cut artwork, allowing you to add or replace new custom artwork to match your joystick theme.

Sized for Agetec HKT-7300 for Sega Dreamcast

%%Panel._Plex_Models_AGETEC%%

The original metal panel found on the HKT-7300 only fits the slightly smaller pushbuttons provided with the original hardware, and does not accomodate 30mm buttons unless widened with a Dremel or similar tool. The 1/30" (1.5mm) thick acrylic replacement panel is designed to fit 30mm snap buttons across Sanwa, Seimitsu, and GamerFinger. It is possible to install some screwbuttons such as Seimitsu PS-14-KN and GN series or Samducksa/Crown.  However, please note that the screw ring will not fit into the small opening surrounding each button, and must catch the threading at the very bottom of the screw button.  Please see our photo gallery for an explanation.   

Durable Configuration. Laser Cut Layout

The top panel is constructed using resilient clear acrylic, and layout is cut to precision with a laser etching device. Each screw hole is countersunk to accomodate the original Agetec screw or similar.

Installation

Note that this install will replace the original metal panel. Also note that the original button harness and connectors are not compatible with standard buttons with a .110" terminal.  You must either replace the wiring entirely, or remove the connectors by cutting them, stripping the wire and attaching a quick disconnect.  Alternatively, you can purchase the .110" Button to Agetec HKT-7300 Harness Adapter (6-Pack).  Save 25% when you select this option.

%%Panel._Plex_AGETEC_Notes%%

%%Panel._Plex_Keychain%%

%%Panel._Plex_Tab_OptionsHelp_Blank%%

%%Panel._Plex_Tab_CPTemplates%%

%%Panel._Plex_Tab_Support%%